11: Monitor
xPico® Wi-Fi® Embedded Device Server User Guide
57
Configuration
Configure the monitoring of a connected serial device through specific configuration settings
pages : Initialization, Control, Poll , Filter, and Data. Access the configuration options displayed in
Table 11-2
on the
Initialization
page. These configuration fields are the same ones in
Step 1:
Setup Initiation
if utilizing Explorer.
Table 11-2 Monitor Initialization Settings
Access the configuration options displayed in
Table 11-3
on the
Control
page. These
configuration fields are the same ones in
Step 2: Setup Commands
if utilizing Explorer.
Table 11-3 Monitor Control Settings
Initialization
Settings
Description
Initial Delay
Set the initial delay time in milliseconds before the monitor starts processing the
initialization message. This field also appears in
Step 1: Setup Initiation
.
Message <Number>
Note:
In other pages
(
Commands/Control
and
Poll
) in Explorer
or under
Configuration,
additional
Message
<Number>
fields will
become available to
further filter and
specify the information
you wish to monitor.
Click the
Edit
link to edit a specific message; this is where a command is entered.
Four message fields will open to allow configuration of a specific command. When
you begin entering information in these fields, additional
Message <Number>
options become available containing the four message fields which will also open
upon clicking
Edit
. Complete the
Message <Number>
fields:
Command
: enter the command in binary format (printable characters or binary
string)
End Character
: indicate as a single printable character or as a control character.
Control characters may be input as
<control>J
,
0xA
(hexadecimal) or
\10
(decimal).
Length
: set the length of the response.
Timeout
: set the timeout length. Minimum timeout length is 100 milliseconds.
Click
Submit
after making changes to get real time response displayed if you are
utilizing Explorer.
Control Settings
Description
Message
<Number>
Note:
In other pages
(
Commands/Control
and
Poll
) in Explorer
or under
Configuration,
additional
Message
<Number>
fields will
become available to
further filter and
specify the information
you wish to monitor.
Click the
Edit
link to edit a specific message; this is where a command is entered.
Four message fields will open to allow configuration of a specific command. When
you begin entering information in these fields, additional
Message <Number>
options become available containing the four message fields which will also open
upon clicking
Edit
. Complete the
Message <Number>
fields:
Command
: enter the command in binary format (printable characters or binary
string)
End Character
: indicate as a single printable character or as a control character.
Control characters may be input as
<control>J
,
0xA (hexadecimal)
or
\10 (decimal)
.
Length
: set the length of the response.
Timeout
: set the timeout length. Minimum timeout length is 100 milliseconds.
Click
Submit
after making changes to get real time response displayed if you are
utilizing Explorer.
