11: Monitor
xPico® Wi-Fi® Embedded Device Server User Guide
58
Access the configuration options displayed in
Table 11-4
on the
Poll
page. These configuration
fields are the same ones in
Step 3: Define Filters
if utilizing Explorer.
Table 11-4 Monitor Poll Settings
Access the configuration options displayed in
Table 11-5
on the
Filter
page. These configuration
fields are the same ones in
Step 3: Define Filters
if utilizing Explorer.
Table 11-5 Monitor Filter Settings
Poll Settings
Description
Message
<Number>
Note:
In other pages
(
Commands/Control
and
Poll
) in Explorer
or under
Configuration,
additional
Message
<Number>
fields will
become available to
further filter and
specify the information
you wish to monitor.
Click the
Edit
link to edit a specific message; this is where a command is entered.
Four message fields will open to allow configuration of a specific command. When
you begin entering information in these fields, additional
Message <Number>
options become available containing the four message fields which will also open
upon clicking
Edit
. Complete the
Message <Number>
fields:
Command
: enter the command in binary format (printable characters or binary
string)
End Character
: indicate as a single printable character or as a control character.
Control characters may be input as
<control>J
,
0xA
(hexadecimal) or
\10
(decimal).
Length
: set the length of the response.
Timeout
: set the timeout length. Minimum timeout length is 100 milliseconds.
Click
Submit
after making changes to get real time response displayed if you are
utilizing Explorer.
Delay
Set the initial delay time in milliseconds before the monitor starts processing the
initialization message. This field appears in
Step 1: Setup Initiation
.
Filter Settings
Description
Rule
<Number>
Click the
Edit
link to edit a specific rule. Two rule configuration fields will open for
this rule. When you begin entering information in these fields, additional
Rule
<Number>
options become available containing the two rule configuration fields
which will also open upon clicking
Edit
. Complete the
Rule <Number>
fields:
Source
: indicate the input of the filter. For example, if the source of this filter is
the second trunk of data created by filter 1, the source should be set to 1.2. A
Source of 0 indicates the raw response.
Mode
: select filter mode (All, Delimiters or Binary)
Delimiter <Number> Binary String
: Enter the filter breaks input up to 8 trunks
separated by binary string. Each trunk will not contain the delimiters. This field
appears when Delimiter Mode is selected.
Start index
: set to indicate when delimiters filter start breaking input into trunks,
if the Delimiter Mode is selected.
Offset
: set the size of the first trunik of data created by the binary filter, if
selected.
Length
: set the size of the second trunk of data created by the binary filter, if
selected. The third trunk of data created by the binary filter will contain the rest of
the input.
