Appendix A: Command Reference
xPico® Wi-Fi® Embedded Device Server User Guide
91
only once.
Delay
has units of seconds.
configgroup Monitor Filter
These settings pertain to
Monitor Filter
in the device.
Filter settings will be applied to all received response. Filter results can be used to feed another filter or use
as Data Reference.
configitem Rule
value Source
Sets the
Source
in dot number format.
Source
defines the input of a filter. E.g. If the source of this Filter is the second trunk of data created by
filter 1,
Source
must be set to "1.2". A
Source
of "0" indicates the raw response.
Dot number format could be "0" or two numbers separated by a dot (e.g. "1.2").
Source
may contain up to 6 characters.
value Mode
Sets filter
Mode
.
All
makes filter ouput to be a duplicate of input.
Delimiters
filter breaks input up to 8 trunks separated by
Binary String
. Each trunk will not contain the
delimiters.
Binary
filter breaks input into 3 trunks according to
Offset
and
Length
.
Mode
may be "All", "Delimiters" or "Binary".
value Delimiter Binary String
Sets
Binary String
delimiter in binary format.
Delimiters break input up to 8 trunks separated by (but not containing) delimiters. A delimiter is
recognized if any of the
Binary String
is completely matched.
Binary format takes printable characters (e.g. 'abc' for characters 'a', 'b' and 'c') or binary string (e.g. [0xa,
0xd] for line feed and carriage return).
Binary String
may contain up to 6 bytes.
value Start Index
Sets
Start Index
to indicate when
Delimiters
filter starts breaking input into trunks.
value Offset
Sets
Offset
for the size of the first trunk of data created by
Binary
Filter.
Offset
has units of bytes.
value Length
Sets
Length
for the size of the second trunk of data created by
Binary
Filter. The third trunk of data
created by
Binary
Filter will contain the rest of input.
Length
has units of bytes.
