Installation Instructions
Installation Instructions
Lens installation
Lens hood installation and removal
Remove the lens back cover. Align the installation mark⑨ on the lens
mount with the corresponding mark on the camera seat, then insert
the lens into the camera seat, and rotate the lens according to the
mounting direction of the purchased mount until the lens is locked
with a click. Do not use excessive force during installation to avoid
damage to the mount.
Align the installation mark ② on the hood with the hood installation
point on the lens, then turn the hood clockwise until it locks the end.
To remove the hood, unscrew it in the opposite direction. (Schematic diagram)
Installing a hood reduces glare and protects the front components of the
lens.
After installing some filters, you may no longer be able to use the hood.
If the hood is not used, the hood can be attached to the lens in reverse.
When shooting with the flash, the hood may block light and cause
vegetating on the image. Therefore, when using the camera flash or
using an external flash with insufficient height, remove the hood before
shooting.
Lens removal
After turning off the camera, press and hold the lens release button on
the camera, rotate the lens in the opposite direction according to the
mounting direction of the purchased mount, and then pull the lens out
of the seat.
After installing the lens, try rotating the lens to see if it is fixed on the
camera.
Since this is a non-CPU lens, data information cannot be provided, so
turn on the “Lens-free release shutter” function in the camera.
Summary of Contents for D-Dreamer F2.0
Page 2: ...LAOWA FF 15mm F2 0 D Dreamer...
Page 3: ...LAOWA FF 15mm F2 0 D Dreamer 110 2 500g FEC Frog Eye Coating 3 ED Glass...
Page 4: ......
Page 5: ...CPU...