21
4
Configuration: Settings
Menu:
SETTING / Temperature
Command:
<ESC>T
d
<CR>
Setting the thermal energy for the heated roller for lamination. The correct
temperature must be experimentally determined with consideration to the
lamination speed, the film and the plastic card. The presetting must be considered
a guideline value.
Setting range(
d
):
120...150...180 degree C
Menu:
SETTING / Lamination Speed
Command:
<ESC>G
d
<CR>
Setting of the transport speed of the document during lamination. The correct
speed must be experimentally determined with consideration to the lamination
temperature, the laminate film and the plastic card. The presetting must be
considered a guideline value.
In order to carry out a test it is possible to start the motor via
Setting range(
d
):
4...6...20 mm/s
Menu:
SETTING / Delay Heatroller
Command:
<ESC>D
d
<CR>
Setting the waiting time, once the heated roller has lowered and lies on the
document. Only after this time does the actual lamination start.
Setting range(
d
):
0...200...2000 ms
Menu:
SETTING / Transport Speed
Command:
<ESC>H
d
<CR>
Setting the transport speed of the plastic card outside of lamination. In order to
carry out a test it is possible to start the motor via .
Setting range(
d
):
40...60...80 mm/s
