Menu:
DEVICE / Foil Type
Command:
<ESC>K01;
p
<CR> und <ESC>K20;
p
<CR>
Setting the film type.
Setting range:
p
p
K01 = 1, K20 = 1: Patch (allways with Index)
K01 = 0, K20 = 1: Hologram with Index
K01 = 0, K20 = 0: Hologram without Index
23
4
The difference between patch and thin film with/without black marking is another
lamination position of the card.
Menu:
DEVICE / Operation Mode
Command:
<ESC>K02;
p
<CR>
The laminator operates in 3 different modes. 1 of these is exclusively suitable for
test purposes only in menu.
Setting range:
p
0 = Normal
1 = Skip lamination
Test: Normal Hoff
3 = Front lamination, if alternative foil
4 = Back lamination, if alternative foi
The standard setting is "normal" and reflects normal operation.
With the setting "Skip lamination" the plastic card is not laminated. Heating is on
without WAIT-Status.
"Test: Hoff" also reflects the normal operating process, but the heating is off in
this case.
Menu:
DEVICE / double-sided
(only with optional flipper)
Command:
<ESC>K04;
p
<CR>
(only with optional flipper)
Cards are laminated on both sides. In addition the optional flipper is required.
Setting range:
0 = double-sided inactive
1 = double-sided active
Configuration: Device