When inserting or exchanging holographic film without an index mark proceed as
follows:
• Open housing cover, if necessary unlock the lock first
• Switch off the device and let it cool down
• Release the heated roller interlocking. To do so push the lever (3) up.
• When exchanging the film additionally empty carrier rollers (1,2)
• Switch on the device.
• Slide the film roll onto the unwinding carrier roller (1) until it reaches the
limit stop.
• Slide an empty film core onto the winding carrier roller (2) until it reaches the
limit stop.
• Insert the film in accordance with the drawing shown above. Attach the start
of the film to the empty core with adhesive tape.
• Close the heated roller interlocking. To do so push the lever (3) down.
• Transport film with to the start and when doing so check that the film
runs correctly and crease-free.
Inserting a document
Insert the passport (1) in the feed table (2) and slide it forwards until it reaches
the middle edge (3). The rocker (4) closes, takes hold of the document and
draws it in.
1
2
3
4
13
2
Summary of Contents for Roll Laminator PL-LR
