8
Make the Header flush with the top of the Post.
Also the inside corner of the 45 Degree cut
should be flush with the end of the Post.
Insert the
3/8”x10 1/2” Through bolt, and a 3/8”
Washer, through the post.
Place a
3/8” Washer on the other end of the Through
bolt and Fasten a Hex nut to the bolt. Using a 9/16”
Socket, tighten the through bolt. Repeat theses steps
on the opposite end of the Assembly Header.
Lift the first Assembled Header in place.
This Line Indicates the Pre-
Drilled hole in the Post. Align
this hole with 1 of the Pre-
Drilled holes in the Beam
3/8” Washer
3/8”x10 1/2”
Through Bolt
3/8” Washer
3/8” Hex Nut
If Anchoring to Concrete, Use either (2) Tapcon
Screws or (1)
1/2”x4” Powers Wedge Bolt. These
are not Provided. Follow the Manufactures
recommendations on installing these fasteners.
If Anchoring to Wood, Use either (2)
1/4” Screws
or (1)
1/2”x4” Lag. These are not Provided. Follow
the Manufactures recommendations on installing
these fasteners.