7 Appendix – Mounting of the micro switch connector
Bag content Trident connector
1.
Cross-sectional area 14 - 26 AWG
2.
Strip 6 mm of the wire. Twist the braids
and pre-tin contacts and wire.
3.
Solder wire to contact
4.
Separate the endbell clamping parts
5.
Pass the wires/cable through the endbell
6.
Insert the insulator into the coupling nut
7.
Insert contacts into cavaties A & C.
Position B & D are preloaded to prevent a
wrong positioning of the contacts.
8.
Screw the endbell to the connector and
hand tighten
9.
Select and fit a suitable clamp bar for
your wire/cable and tighten screws.
U.I. Lapp GmbH
D-70565 Stuttgart/Germany
www.lappgroup.com
A Company of the Lapp Group
