16
EXCALIBUR LINER
English
I3
I2
I3
I1
I4
I5
I6
•
Release the residual pressure by holding down the trigger of
the gun and pointing it into a container.
•
Eliminate the paint remaining within the tank (
I2
) by placing
the re-circulation tube (
I3
) into a container.
•
Open the recirculating-safety valve (
I4
).
Follow the washing procedure before using again
the equipment.
•
Empty all of the wash fluid from the tank and turn off the
equipment.
•
Turn the pressure adjustment handle (
I1
) to minimum
(pump
stopped)
.
•
Shut off the motor.
•
In case of long storage, we recommend you to suck and
to leave light mineral oil inside the pumping group and the
flexible hose.
• Turn the pressure adjustment (
I1
) handle slightly clockwise
to make the machine function at minimum pressure
(pump
activated)
, until the tank has been completely emptied then
shut off the pump by bringing the handle (
I1
) to its minimum
position.
•
Fill the tank (
I2
) with wash fluid.
•
Clean the walls of the tank with a brush.
•
Turn the pressure adjustment (
I1
) handle slightly clockwise
to make the machine function at minimum pressure
(pump
activated
).
•
Make sure the re-circulation tube (
I3
) is inserted into a con-
tainer and wait for clean wash fluid to come out of it.
•
Turn the pressure adjustment handle (
I1
) to minimum
(pump
stopped)
.
•
Place the re-circulation tube back into the tank.
•
Keep the gun’s trigger pressed to release any residual pres-
sure.
•
Remove the nozzle from the gun and wash it separately.
•
Closed the recirculating-safety valve
•
Turn the pressure adjustment handle (
I1
) slightly clockwise
to make the machine function at minimum pressure
(pump
activated
).
•
Point the manual gun (
I5
) into a container (
I6
), drain the
residual paint and wait for the wash fluid to come out clean
the entire spraying circuit.
I
CLEANING AT THE END WORK
•
Reduce pressure to the minimum (
turn counterclockwise the
pressure control knob (
I1
)
).