7
English
G3
G2
G5
G4
G1
oN
oFF
WASHING oF THE NEW EQUIPMENT
•
The equipment has already been adjusted at our factory with
light mineral oil left inside the pumping group as protection.
Therefore, wash with diluent before sucking the product.
•
Lift the suction pipe and dip it into the solvent tank.
•
Ensure the gun (
G1
) is without nozzle.
• Turn the key (
G2
) of the equipment to the
oN
(I)
position.
•
Turn clockwise the pressure control knob (
G3
) so as the
machine works at idle speed.
•
Point the gun at the solvent tank and press the trigger so as
to recover the residual solvent.
• As soon as the pump starts to over-rev turn the key to the
oFF
(0)
position to switch off the equipment.
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact between
the solvent fumes and the electric motor.
•
Now the machine is ready. Should you use water paints,
besides the solvent wash, a wash with soapy and then clean
water is suggested.
•
Insert the gun trigger lock and assemble the nozzle.
PREPARATIoN oF THE PAINT
• Make sure the product is suitable to be used with a spray
gun.
The use of non-compliant products causes
damage to the machine thus annulling the
guarantee
(only use specific filtered paints for
airless applications)
.
Make sure the product to be used is compatible with
the materials employed for manufacturing the equip-
ment
(stainless steel and aluminium)
. Because of that,
please contact the supplier of the product.
Never use products containing halogen hydrocarbons
(as methy-
lene chloride)
. If these products come into contact with aluminium
parts of the equipment, can provoke dangerous chemical reactions
with risk of explosion.
• Remove the suction pipe and take away the solvent tank.
• Point the gun (
G4
) at a container (
G5
) keeping the trigger
pressed
(so as to drain the oil inside)
till a clean solvent
comes out. Now, release the trigger.
