Ed. 003 - 02/2013
F
Never put hand or fingers over the nozzle.
Never wipe off build-up around the fluid nozzle until
pressure is fully relieved and the gun trigger lock
is engaged.
Never try to stop or deflect leaks with your hand
or body.
This is a high pressure dispensing gun.
Fluid dispensed under high pressure could
be injected through your skin and into your
body. This could cause extremely serious
injury, including the need for amputation.
Also, fluid injected or splashed into the eyes
or on the skin can cause serious damage.
FLUID INJECTION HAZARD
Always follow the Pressure discharging Procedure, as hereby
described, before cleaning or removing the fluid nozzle or servicing
any system equipment.
PRESSURE DISCHARGING
PROCEDURE
To reduce the risk of serious injury, including fluid injection, splashing
in the eyes or on skin, always follow this procedure whenever the
dispensing equipment is shut off, when checking or servicing any
part of system, when installing, cleaning or changing nozzles and
whenever you stop dispensing.
• Fully release the gun trigger and set the gun trigger lock by
rotating the trigger lock forward.
MEDICAL ALERT – FLUID INJECTION WOUNDS
If any fluid appears to penetrate your skin, get EMERGENCY
MEdICAl CARE AT ONCE. dO NOT TREAT AS A SIMPlE CUT.
Tell the doctor exactly what fluid was injected.
Injection into the skin is a traumatic injury. It is
important to treat the injury surgically as soon as
possible. Do not delay treatment to research toxicity.
Toxicity is a concern with some exotic materials
injected directly into the blood stream. Consultation
with a plastic surgeon may be advisable.
•
Shut off the supply pump.
•
Hold a metal part of the gun firmly to the side of a grounded
metal waste container.
•
disengage the trigger lock (
G1
) by rotating the trigger lock
backward. Trigger the gun to relieve fluid pressure.
• Fully release the gun trigger and set the gun trigger lock (
G1
)
by rotating the trigger lock forward.
•
Open the pump drain valve to help relieve fluid pressure in the
pump, hose, and gun. Triggering the gun to relieve pressure
may not be sufficient. Have a container ready to catch the
drainage.
•
leave the drain valve open until you are ready to dispense
again.
G
www.larius.com
L400 SPRAYING GUN
12
G1
Lock trigger
Unlock trigger