3
mm
Step 2 Installing Steering Rod, Headset and Easy-Up
5
mm
4
mm
3
4
5
6
1
B.1
2
B.2
FIG. A
FIG. B
1
2
Steering Rod
Easy-Up
Headset
Loosen the headset adjustment ring on the Easy-Up
(1)
and tighten the adapter sleeve bolt (in the bottom) with
5mm hex (6Nm)
(2)
Apply grease to bearing cups and crown race.
Install Bearings and Steering Rod:
Place lower bearing
into the lower cup and snap the dust seal in properly.
Slide Steering Rod through frame from below and
support the bottom of it (so it doesn’t fall out).
Drop upper bearing into the top cup , place
compression ring and top cover in the correct
order, followed by the spacer
Place the Easy-Up all the way into the Steering Rod
(by tapping it downward gently) and tighten 2x4mm
hex clamp bolts (5-6 Nm) (
FIG. A
)
Tighten the headset bearings with the adjustment ring
by turning clockwise by hand. (
FIG. B.1
)
Secure the adjustment ring by tightening the 3mm hex
fixing bolt. (3 Nm) (
FIG. B.2
).
Tighten Quick Release (QR) clamp.
2.0
2.1
2.2
1
3
4
5
6
2
Components
Tools
6
2
3
4
5
1
2.0
2.1
2.2
