NMS045 Reference Manual
Installing the NMS045 on the TRP019 Pole
3-8
FIGURE 3-11
EPS2116 Threading
Step 5
Holding the windscreen and birdspike over the top, screw
the assemblies together.
TAKE NOTE
"Step 5" can also
be done after you calibrate.
see 3.6 "Calibrating the 831C"
CAUTION
If you need to remove the windscreen, do not pull it off the
birdspike with an upward motion. This will damage the weather
protection. First, unscrew the birdspike by twisting its top. Then pull
the windscreen down over the bottom of the unscrewed birdspike.
3.3.5 Installing Components in the Box
Step 1
Connect the CBL222-20 to the top of the 831C.
1
2
4
3
Thread the CBL222-20 cable up
through the base and top of the
EPS2116.
Align red dots on bottom of
preamplifier to top of CBL222-20,
gently push together until
mounted. (This step can be done
after the EPS2116 is mounted to
the pole, but attaching it now
prevents the CBL222-20 from
slipping into the pole).
With the preamp on the outside of
the assembly, carefully screw the
base of the EPS2116 on the pole.
Do not twist the CBL222-20 or the
PRM2103-FF. Hold steady as you
mount the EPS2116 on the pole.
Gently ease the cable into the
EPS2116 until the microphone is
seated at the top.