READ AND FOLLOW ALL SAFETY INSTRUCTIONS
! IMPORTANT SAFEGUARDS !
WHEN USING ELECTRICAL EQUIPMENT, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
SAVE THESE INSTRUCTIONS
THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
1.
Do not join converter connector until installation is complete and AC Power is supplied to the emergency driver.
2.
This product is for use with an emergency LED lighting load and supplies nominal 10.0 W of power with a
maximum voltage of 50 VDC in emergency mode for a minimum of 90 minutes.
3.
Make sure all connections are in accordance with the National Electrical Code or Canadian Electrical Code and
any local regulations.
4.
To reduce the risk of electric shock, disconnect both normal and emergency power supplies and converter
connector of the emergency driver before servicing.
5.
This emergency driver is suitable for factory installation only.
6.
This product is suitable for use in damp locations where the ambient temperature is 0ºC minimum, +55ºC
maximum. Product is also suitable for installation in sealed and gasketed fi xtures. Product is not suitable
for heated air outlets and wet or hazardous locations. Maximum allowable case temp is 65ºC.
7.
An unswitched AC power source is required (120-277 VAC, 50/60 Hz).
8.
Do not install near gas or electric heaters.
9.
Do not attempt to service the battery. A sealed, no-maintenance battery is used that is not fi
e
ld replaceable.
Contact the manufacturer for information on service.
10.
The use of accessory equipment not recommended by the manufacturer
,
may cause an unsafe condition.
11.
Do not use this product for other than intended use.
12.
Servicing should be performed by qualified service personnel.
13.
Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
14.
For Canadian application
,
the output terminals should be in compliance with the accessibility requirement of
the
Canadian Electric Code.
15.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this
device may not cause harmful interference, and (2) this device must accept any interference that may cause
undesired operation.
16.
This product must be grounded. See the wiring diagrams for details.
Ni - Cd
EMGBALL-LED3
Replacement Emergency Backup Ballast
for EMG Explosion Proof LED Light Fixtures
Instruction Manual
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
