LarsonElectronics.com • Phone: 1-800-369-6671 • Email: sales@larsonelectronics.com
Page 1 of 5
LARSON ELECTRONICS
9419 US-HWY 175
Kemp, TX 75143 USA
INSTALLATION, OPERATION & MAINTENANCE DATA SHEET
EPCO-20A S
ERIES
CONNECTOR
EPCO-20A
SERIES for use in:
®
Class I, Groups B, C & D; Class II,
US ®
Class II, Groups F* and G, Class III
Groups F* (Coal or Coke Dust) and G,
Class III
Type 3, 4 Locations, as defined by the Canadian Electrical Code and the National Electrical Code.
READ THIS SHEET CAREFULLY BEFORE BEGINNING INSTALLATION.
WARNING
:
Electrical power
MUST BE OFF
during installation, or performing any maintenance.
Disconnect
primary
power source and
lock out
. This device
must
be installed by trained, qualified and competent personnel. Installation
must
comply with local, state and national regulations, as well as safety practices for this type of equipment.
FIGURE 1
General view of
EPCO
Series CONNECTORS
BREECH LID SHOWN
FLIP LID SHOWN
Breech -
N4X when Cap Closed, N3 when in use.
Flip -
N3 Hinge Up or in use.
Certified for
Intermateability with
Appleton®
& Crouse-Hinds®
plugs.
(
*
: F
without Electrically Conductive dust)
