Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
4
HALD-24-1X150LED-V3
WARNING
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained by a
qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power if OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor
To avoid explosion:
•
Make sure the supply voltage is within the luminair
es’ voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the Luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
•
Substitution of components may impair suitability for Class I, Division 2, Class II Division I.
•
Do not disconnect equipment unless power has been switched off or the area is known to be non-hazardous.
•
Do not let the power cord touch hot surfaces.
•
Do not mount near gas or electric heaters.
•
Equipment should not be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
•
The use of accessory equipment is not recommended by the manufacture and may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
The technical data indicated on the luminaire are to be observed.
•
Changes to the design and modifications of the luminaire are not permitted
•
Only genuine replacement parts are to be used when unforeseen maintenance is required. Consult the factory
at www.larsonelectronics.com or an authorized representative.
The Larson Electronics HALD-24-1X150LED-V3 Hazardous Area LED Light Fixture is designed to provide operators with
a powerful and energy efficient alternative to traditional hazardous location luminaries. This LED panel mount fixture is
ETL listed Class I Divisions 1 & 2, Class II Divisions 1 & 2,and is approved for use within paint spray booths. Cree LED
technology and compact design makes this lamp an excellent replacement upgrade option for paint booths and
hazardous locations where flammable chemical/petrochemical vapors are present.
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 100V - 277V AC, 50 or 60Hz
except those factory ordered with low voltage 11V to 25V AC/DC.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as
shown in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box
or similar device and take precautionary steps for
weatherproofing all connections if installed in a location where water
may come in contact with the unit. Ensure the unit is properly grounded
and that wiring is done according to all local and national electrical/building
codes.
This unit comes preconfigured with cord whip and selected color temp. Once mounted, plug cord into compatible
receptacle with correct voltage. Fixture available in 100-277 Volts AC, 50/60Hz
or
11-25 Volts AC/DC and are not
interchangeable.
Please check product nameplate for correct voltage!
WARNING:
CHECK NAMEPLATE FOR
PROPER VOLTAGE. DAMAGE FROM
IMPROPER VOLTAGE WILL VOID
WARRANTY. FIXTURE AVAILABLE IN
VARIOUS VOLTAGES SELECTED
UPON PURCHASE.
