HALD-48-1X4-2X50LED
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
WIRING
(see attached wiring diagram)
This unit comes preconfigured with cord whip, selected voltage, beam angle, and color temp. Once mounted,
plug cord into compatible receptacle with correct voltage.
Check nameplate for proper voltage.
MAINTENANCE
Caution:
To avoid personal injury, disconnect power to the light and allow the unit to cool down before
performing maintenance.
Warning:
No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void
the warranty.
1.
Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine
checks to be made on a yearly basis. Frequency of use and environment should determine this. It is
recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended practice for Electrical Equipment.
2.
The lens should be cleaned periodically as needed to ensure continued photometric performance.
Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid
cleaner.
3.
Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions or
contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.
4.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
LAMP SERVICE
Each LED assembly is removable should the need for lamp service or replacement occur. To remove a lamp,
follow the steps below.
1.
Disconnect power prior to servicing!
Disconnect power lines prior to releasing fixture for service.
2.
Loosen the screws around the surface of fixture holding the lens.
3.
Remove lens.
4.
Locate the screws holding the lamp to the frame.
5.
Carefully free lamp from housing. Keep hold of lamp when removing.
6.
Service or replace lamp.
7.
Insert lamp into fixture as before and secure.
8.
Connect line wire from lamp to power source.
9.
Replace front lens removed in
step 3
.
10.
Make sure all screws are tight.
11.
Energize fixture.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT
1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
WARNING:
CHECK NAMEPLATE FOR
PROPER VOLTAGE. DAMAGE FROM
IMPROPER
VOLTAGE
WILL
VOID
WARRANTY. FIXTURE AVAILABLE IN
VARIOUS VOLTAGES SELECTED UPON
PURCHASE.
