SECTION 2
Installation
Before you start
•
Check the package contents and make sure that the device in the package is in good condition and all the assembly parts are
included:
—
PTZ camera assembly
—
Pendant adapter
—
Thread tape
—
Hi-Power PoE injector
—
Gloves
—
Hex L-wrench
—
Quick installation guide (this document)
•
Make sure the mounting surface and fasteners are strong enough to withstand at least 8 times the weight of the camera
assembly and the mounting bracket.
•
For cement walls, use an expansion screw to secure the mounting bracket.
CAUTION
Do not carry the camera by the drop cable.
For outdoor installations, refer to “APPENDIX C Lightning and Surge Protection” on page 28 for additional installation
considerations.
2.1 Remove the camera from the packaging
1. Remove the camera from the protective packaging.
2. Remove tape from the dome drive, if attached.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
0
of 30
IP
PTZ
Network
Camera
Setup Guide