3. If the camera drop cable will be routed through the ceiling, mark the location of a hole for the camera drop cable. The drop
cable will be routed through the mounting bracket and can be routed either through the mounting surface or out the side of
the mounting bracket.
4. Drill holes in the mounting screws and hardware. Also, drill a 1½" diameter hole in the mounting surface for the drop cable.
5. Clip the safety cable to the loop on the camera mounting bracket.
6. Route the camera drop cable through the mounting bracket, then clip the safety cable onto the loop in the mounting bracket.
Pendant adapter
Ceiling
Coupling
Drop cable
Safety cable
Align
marks
Back box
Lock screw
7. Fit the camera coupling into the ceiling mounting bracket, then twist the bracket to align the marks on the bracket and the
camera back box. See the figure above.
8. Tighten the two lock screws on the ceiling bracket to secure the camera to the mounting bracket.
9. Feed the camera drop cable through hole drilled at the mounting location, then anchor the mounting bracket to the ceiling.
2.5 Connecting the cables
Drop cables connectors for the
IDCMR-IP-POE-PTZ-20X
are shown below. Each wire is labeled with its purpose.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
4
of 30
IP
PTZ
Network
Camera
Setup Guide
