Injector status LEDs
LAN cables for
DATA IN (to network switch) and
DATA and POWER OUT (to camera)
Ground wire
Port labeling
To use the injector:
1. Connect the injector ground wire to an earth ground terminal. (
NOTE
: Not all PoE injectors have a ground wire.)
2. Connect a LAN drop cable between the network switch and the DATA IN port on the injector.
3. Connect a LAN drop cable between the injector DATA and POWER OUT port and the camera LAN drop cable.
4. Plug the power cable provided (not shown) for the PoE injector into the jack on the injector, then into a standard 120 Vac
electrical outlet.
After power is applied to the camera, the camera will perform initial motion checks. Allow these motion checks to complete before
continuing (~ 1 minute).
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
7
of 30
IP
PTZ
Network
Camera
Setup Guide