b.
In the message bar at the bottom of the screen, click
Run
. Follow the on-screen instructions to install
WebComponents
. When the following screen opens, click
Finish
.
The Live View screen with the camera video image should appear.
For more information about the IE browser interface to your camera, go to LarsonElectronics.com for the latest
IP Camera
User Manual
for your camera.
NOTE
:
Most IP cameras have a
Reset
button for returning the camera configuration to its factory settings.
The reset
button needs to be pressed with the camera disconnected from power. Continue holding the reset button down and plug
the camera back into power and continue to hold the reset button for an additional 30 - 45 seconds.
NOTE:
For more details on using the functions of this camera, refer to the instruction manual for the Camera Management
Software (CMS) you are using.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE
AT 1-
FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
877-348-9680
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
23
of 30
IP
PTZ
Network
Camera
Setup Guide
