Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
3
IMPORTANT NOTICE
If searchlight DC power is disconnected (wires disconnected from battery or power supply switched off), after
reconnecting to power, make sure to turn on the searchlight using the wireless or wired remote, to make a full 360°
rotation, in order to reset the home position memory.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
Th
is spotlight
is designed to provide years of reliable performance. Should the need for replacement parts arise, please
contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
SALES@LARSONELECTRONICS.COM
OR BY PHONE AT
1-877-348-9680
FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
OPERATION:
1.
Press on/off button to Switch on or off searchlight.
Change direction of the light beam by pressing the direction buttons.
2.
Utilize the Function button to switch speed
Up
Button
Down
Button
Left
Button
Right
Button
.
Fn
Dual speed (Fast / Slow)
HANDHELD WIRELESS REMOTE PROGRAMMING:
1.
Switch off DC Power or disconnect from battery.
2.
Make sure there is NO other transmitter
operating at the same time.
3.
Switch on DC power, within 5 seconds press
r
emote up ▲ and down ▼button
once
simultaneously.
4.
Searchlight will flash to acknowledge the
remote. Connection has been made.
5.
Up to 4 remotes may be used with the
searchlight (programming a fifth remote
will
replace the first). To program a second
remote, within five seconds of
programming
the first remote, press the second remote
’s up
and down button
once simultaneously. Repeat
to program additional remotes.
NOTE:
The included running lights are
always on when mount is receiving power.
The wireless remote control only controls the
search light and NOT the running lights.
LE-4100-6-A
