LLP-JD-TR-4040-V1
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
1
WIRING
•
Power is attached via cord on back of light.
Cords connected via Deutsch
connector
for
LED25WRE-CPR
, allowing for quick and easy connections.
•
See wire diagram for connecting power
to LED18W-PAR36
. Red is positive
and Black
is negative.
•
Take appropriate measures for waterproofing connections when installed in an
area
prone to getting wet.
•
Different cord options are available from Larson Electronics.
POWER
•
LED18W-PAR36
is compatible with input voltages of
10
-
30
V DC.
•
LED25WRE-CPR
is compatible with input voltages of 12-32V DC.
PLEASE NOTE:
There is no difference in light output between voltages.
MOUNTING
LED18W-PAR36
light bar is capable of emitting up to 1,800 lumens during operation. This
PAR36 LED lamp operates on 10-30V DC, including 12V DC and 24V DC. When in use,
the luminary emits 1,800 lumens in a flood beam configuration with color temperature
options of 3000K, 4500K or 6000K. Please make your color temperature selection when
ordering below. A total of six, three-watt LEDs can be found inside the unit. The PAR36
LED light is equipped with a clear, polycarbonate lens for close range illumination.
LED25WRE-CPR
lights feature a smaller profile and lighter weight than our LEDLB-E
series lights, making them ideal for use in locations where traditional lights cannot fit or
would block other mounted equipment. The LED25WRE-CPR is suspended within a form
fitting trunnion (yolk-type) mount. This trunnion mount has two knurled knobs that can be
loosened, allowing the LED light to be adjusted and then retightened to lock the light into
any desired position once mounted. A single stainless steel stud protrudes from the bottom
of the mount, enabling the operator to install the light using a simple through-hole mount,
allowing the unit to be installed anywhere a 1/2-inch hole can be drilled.
Deutsch Connector
Mounting Bolt
-
LENS
Adjustment
Screw
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
SALES@LARSONELECTRONICS.COM
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The EPP-20A-25P is designed to provide years of reliable performance. Should the need for replacement parts arise,
please contact Larson Electronics.
