Megatower
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
17 of 6
7
F
igure
3
.
1
2.2
Turn the mast switch to RAISE. (
WATCH THE
MAST CABLES TO ENSURE THEY DO NOT
GET SNAGGED WHILE ELEVATING!
Cables are
positioned and designed to prevent snags, but it is
highly recommended to watch the cables as the mast
raises to ensure no snags occur.) NOTE:
The unit
take at least 10 minutes to fully raise.
NOTE: For safety, this unit is equipped with
a wind speed reader. If the wind is too severe
(25mph+),
the
unit
will
not
raise
and will automatically lower when speeds are
too high and will not raise until wind speeds
drop
below
severe
speed.
It
is
recommended to fully lower the mast to its
original position
when wind speed is too high.
Figure
3
.
1
3
When wind speeds are too high and the mast
auto-retracts, the red ERROR light will turn on on
the control box.
3.13.)
To turn on the lights, the
breakers 1, 2,
3,and 4
in the box above the control box need to be
flipped
ON
. Once
the breakers are ON
, you can
turn the desired light switches on the control box to
the ON position to turn lights on.
To turn the lights off, simply turn the light switches to
the OFF position.
DO NOT flip any breakers in the
box above the control box off.
