SLEDB-110V-MS
Larson Electronics, LLC
Phone: (
877
)
348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
5
MOUNTING
Mount to any flat surface capable of holding the weight utilizing the predrilled
mounting holes. Mount in any direction as long as the motion sensor can still detect
motion.
WIRING
We strongly encourage a licensed electrician install this product, especially in outdoor locations
where weatherproofing may be required. Voltage driver permits operatio
n at
110-120V AC
.
W
arning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture
wires as shown in the diagram
Take precautionary steps for weatherproofing
all
connections if installed in a location where water may
come in contact with the unit. Ensure the unit is properly
grounded.
The Larson Electronics SLEDB-110V-MS Class II Beacon works on 110-120V AC, offers a choice of several colors
and is equipped with an aluminum base. The SLEDB-110V-MS comes equipped with a motion sensor that turns the
light on when movement is detected. The motion sensor has a user adjustable time delay.
INSTALLATION
This unit comes pre-assembled with the selected color from factory. Follow the steps below for installing and
maintaining the strobe light.
