TPM-LEDLB-32E
MOUNT SCREW
WIRING
We strongly encourage a licensed electrician install this product, especially in outdoor locations where
weatherproofing may be required. Universal voltage driver permits operation at 9-42V DC.
Each light comes with a detachable 16 foot coil cord with cigarette plug. The cord is detached via a
weatherproof, 2 pin Deutsch connector which easily and securely attaches and detaches the coil cord from the
spotlight. Other cords, including 21 foot cords with ring terminals (C-21RT), 16 foot cord with spring battery
clamps (alligator clips) (C-16BC) and a 16 foot straight cord with cigarette plug (C-16CP) are available. This
light can be ordered in either 12 volt or 24 volt configuration, allowing it to be used with any vehicle or ATV
equipped with a cigarette plug. Choose voltage when ordering.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as
shown in the diagram
Secure each pair with a wire nut according to the diagram.
Utilize a junction box or similar device and take
precautionary steps for weatherproofing all connections if
installed in a location where water will come in contact with
the unit. Ensure the unit is properly grounded.
Submersible to 3 Meters
This LED wall pack is IP68 waterproof
for
temporary submersion (<60 minutes)
and built to
resist the
damaging effects of an outdoor environment. It can be used underwater
(<60 minutes)
and above water.
The
luminaire is submersible up to 3 meters.
LIGHT POLE OPERATION
1.
Place Golight on top mounting bracket using predrilled mounting holes. Route
cable through mounting plate
down to power source.
2.
Place mounting bracket over the top pole and tighten hand screw.
3.
Place pole in its mount and secure.
4.
Extend pole by lifting upwards. Two self-locking collars hold the pole in any
position. Once let go, the pole will
stay in place.
5.
To lower pole, lift the self-locking collar for each section. The pole is air
cushioned and will lower softly. See
below.
This pole features a pneumatic braking system that prevents unexpected or sudden collapse of the pole. If the pole is
loaded with a pair of heavy fixtures for instance and the operator inadvertently releases the locking tabs, the pole will
simply ease down gently rather than suddenly collapse. This is a great feature when mounting expensive electronic
devices and you’d like the added security of knowing there is no chance of serious damage should the pole be
released.
USE AND CARE
Always check damaged or worn out parts before use. Broken parts will affect operation. When not in use,
store in a secure place out of the reach of children. Inspect it for good working condition prior to storage and
before re-use.
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
