WAL-QPW-4XWP60E-25C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
3
The WAL-QP-2X500LTL-LED-100 Quadpod Mounted LED Work Area Light from Larson Electronics produces
120,000 lumens and is equipped with 100 of SOOW cable. This LED light tower is designed for portability and
durable operation and ideal for use in demanding conditions. Dual 500 Watt LED light heads cover up to
70,000 square footage.
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK
Do not use with extension cord near water or
where water may accumulate.
Keep plugs and receptacles dry.
For use only on GFCI protected circuits.
Risk of burns, do not operate without lens.
Lighted lamp is hot. Keep away from
combustibles.
WARNING RISK OF FIRE, ELECTRIC SHOCK,
EXPOSURE.
TO EXCESSIVE UV RADIATION OR INJURY TO
PERSONS
Unplug and allow cooling before replacing bulb.
Light
gets HOT quickly
Do not touch hot lens guard or enclosure.
Do not remain in light if skin feels warm.
Do not look directly at lighted lamp.
Keep lamp away from materials that may bum.
Do not operate the lamp with missing or
damaged guard, l
ens, or cord.
QUADPOD ASSEMBLY
The quadpod assembly consists of 3 parts:
1.
Light head
2.
Pole w/Legs
3.
Wheel base
To assemble quadpod, begin by placing the legs over the wheel base. Tighten bolt to secure the
wheels. The quadpod can now be rolled around on its wheels. Ensure the legs are folded up before
tilting quadpod to maneuver.
WARNING:
Use caution before tilting quadpod with a heavy load. For heavy loads, it is
recommended to remove the light head prior to transporting via wheel base! Failure to do so may
cause serious injury or death. Larson Electronics shall not be held liable for injuries caused by
misuse.
1.
Place tower in desired location that is flat and able to support the quadpod without falling over.
2.
Loosen
lower
hand screw and lower legs until firmly stabilizing quadpod.
3.
Tighten hand screw to secure legs.
4.
With help, place the light head over top pole and tighten
top
hand screw.
Lightweight lamps can be attached by tilting quadpod toward the ground with the legs up. Attach light
head to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt quadpod while
extended to max height. It is recommended to have another person hold the quadpod while tilting
vertically.
240W General Area LED Crank Up Light Tower
Adjustable 12' to 20' - (4) LED Lamps - 20' 16/3 SOOW Cord
Instruction Manual
