1660K023G
Page 5 of 30
Parameter 3: Time offset:
This parameter allows the user to configure its time zone, as well as changing the
time offset in summertime/wintertime when configuring it manually, or for personal purposes; always counting
that internal time count of the clock is GMT. First digit shows an upper hyphen when adding time and a
hyphen when subtracting
Parameter 4: Display configuration
: This parameter configures other functionalities of the display, as the
brightness and the sync options.
Brightness configuration consists of two parts:
Left digit. Manual or automatic control of brightness
0 - Automatic control of brightness depending on the room light.
1 - Manual control of brightness. Fixed brightness depending on the right digit.
Right digit. Brightness level.
The functionality of this digit depends on the left digit:
Automatic
mode
– Selection of the minimum brightness of the display when the room is in
darkness. Minimum brightness is 1 and maximum is 5. With light, the display adapts to the amount of
light in the room.
Manual mode
- Selection of the brightness level. 1 is minimum and 5 is maximum brightness
The second parameter (Accessed through the Enter key once selected the brightness configuration)
configures the time sync depending on the capabilities and the user desires. If the user selects a sync not
allowed by capabilities, the display will not sync. For example, a display without Ethernet connection, selecting
SNTP sync will have no effect. Options are:
0. Do not sync.
1. Sync with another display through Ethernet.
2. Sync through SNTP.
3. Sync with another display through RS-485.
4. Sync through GPS.
Parameter 5: Display power-up time:
This parameter configures the time the display changes form power-
.save mode to full-operative mode. When accessing in this parameter, the hour the display changes to full-
operative mode is shown. When the Enter key is pressed, the minutes are shown. To go back to the
parameter menu, press the Enter key again.
Parameter 6: Display power-down time:
This parameter configures the time the display changes from full-
operative mode to power-save mode. When accessing in this parameter, the hour the display changes to
power-save mode is shown. When the Enter key is pressed, the minutes are shown. To go back to the
parameter menu, press the Enter key again.
Parameter 7: Website language. This parameter is shown if the display includes Ethernet option.
0 - Catalan
1 - Spanish
2 - English
3
– French
4 - German
Parameter 8: Display IP. This parameter is shown if the display includes Ethernet option.
This
parameter allows the user to change the IP address of the display. Access this parameter pressing the
Advance key. Once inside, the first number of the IP address is shown. Modify it using the Increase and
Advance keys and validate it using the Enter key. Do the same with the other 3 numbers of the IP address. To
identify each number, think that the first number is shown without decimal point. Next numbers appear with
decimal points, shifting left each number.
