1706K45B
Page 4 of 27
Modify parameters
If the user presses the Advance key for 6 seconds the parameter menu is displayed. In all cases the
number the user is modifying is the one that flashes. The complete diagram of the parameters can be found in
annex 1. In order to make configuration easy for the user, when changing a parameter, a point is turned on.
This point changes depending on the sub-parameter (if it exists) the user is in.
8
.
8:88
88
:
88
8
.
8
:
88
88:8
.
8
ENTER
ENTER
ENTER
Parameters are detailed below:
Parameter 1: Date configuration: This parameter configures de date, as well as the wintertime/summertime
automatic switchover configuration. When entering this parameter, the day can be changed using the
Increase and Advance key. To switch to month configuration, press the Enter key. Navigation here is the
same as before. Once set the month, press the Enter key to switch to year configuration. Navigation here is
the same as before. Once set the year, press the Enter key to switch to the following parameter, which has
two parts:
Left digit: wintertime/summertime automatic switchover configuration
0 - Automatic switchover disabled. Time offset must be changed increasing or reducing value
in parameter 3, leaving as the internal time, the UTC time.
1 - Automatic switchover enabled.
Right Digit: Weekday.
It allows to configure the present weekday, where 1 is Monday and 7 is Sunday
Parameter 3: Time offset: This parameter allows the user to configure its time zone, as well as changing the
time offset in summertime/wintertime when configuring it manually, or for personal purposes; always counting
that internal time count of the clock is GMT. First digit shows an upper hyphen when adding time and a
hyphen when subtracting
