L’ARTISTICO SRL |
EN
30
Cod. 40115 | Rev. 19 | 05/2021
CORNER M14, FRATAC V M14:
air fireplaces with side glass / 3 glasses
(1) AIR ENTRY IN THE COATING
: it is obligatory to always ensure a
minimum ventilation inlet and outlet in the coating through a grid at the
bottom and a grid above (decompression) of
at least 450 cm2 each
.
They can be done frontally, laterally or even later, provided that the
circle of air entering and leaving is always inside the house (and not
outside).
(2) INSPECTION DOOR:
The
CORNER fireplaces are equipped
as standard with a black painted
metal door which must be left
visible and accessible for the
opening and closing of the door
hooks. The FRATAC V three-sided
model is equipped with 2 doors,
one on each side. The door can
also be painted, covered, replaced
with a plasterboard door or
removed and integrated into the
largest mandatory inspection door.
To load the pellets in the tank, the
periodic maintenance as well as
the annual cleaning of the flue, the
spare parts, it is obligatory to leave
the electronic components on the
side (in standard on the right, while
looking at the chimney of face with
the exception of the left CORNER)
a sufficient inspection door to
access all components at least
50x140 cm high. The door could
also be made on the back or on the side, allowing access to the entire
interior of the fireplace.
(3) - (4) UPPER HOT AIR FAN
CHANNEL
: These fireplaces are
supplied with two fans to heat the
room air:
• Centrifugal upper right hand fan
of 160 m3 / h with hot air outlet of
Ø 80 mm, normally connected to
an air outlet in the chimney but can
be transported up to a maximum
distance of 6 meters, not
manageable by the customer but
operating automatically according to the power of combustion.
• An upper left centrifugal fan of 160 m3 / h with a hot air outlet of Ø
80 mm that can be driven up to a maximum distance of 6 meters,
manageable by the customer using the remote control (VENT-3 ) from
speed 0 (stop) to 5 (max) or automatic. For optimal installation, we
recommend using thermally and acoustically insulated pipes to ensure
the best acoustic and thermal comfort.
SUPERIOR DEFLECTORS
Each appliance can have smoke deflectors (in vermiculite) to be
placed in the upper part of the combustion chamber.
For the Corner and 3-glass models follow the instructions below:
