L’ARTISTICO SRL |
EN
27
Cod. 40014 | Rev. 04 | 08/06/2018
Verify that the pellet tank is sufficiently charged for the desired
ignition period.
Verify that the ash drawer is in the appliance.
Verify that the grille surrounding the brazier is in place.
Make sure the door is closed
Check that the combustion chamber has been cleaned
To use the remote control and all its functions, follow the instruction
manual of the remote control (code 40112) supplied with the unit.
28. POWER OFF DURING PELLET USE
Switching off the working pellet will take a long time, about 50
minutes. During this time, the screw is emptied of all internal pellets
and the appliance shuts off only when the smoke temperature has
dropped below the safety values.
WARNING: It is absolutely forbidden to interrupt
the automatic shutdown cycle of the pellet working
device. DANGER OF FIRE APPLIANCE.
29. POWER ON WITH WOOD USE
WARNING: Before using the device to firewood,
general cleaning must have been carried out of the
combustion chamber, the grid and the ash drawer
(Chapter 31).
To light the fire suggested using small wood pieces together with
paper or other means of ignition on the market.
The door must be closed.
WARNING It is absolutely forbidden to use
flammable liquids for ignition (such as alcohol, petrol,
oil and the like).
For safety reasons, the appliance door can only be
opened during fuel loading and must remain closed
during operation and periods of non-use. It is forbidden
to overload the unit: Observe the maximum amount of
fuel that can be loaded in the technical data sheet. Too
much fuel and too much air for combustion can cause
overheating and damage the appliance. Damage to
overheating is NOT covered by warranty.
30. POWER OFF DURING WOOD USE
Turning off the working wood is a natural process that is obtained by
not feeding the wood inside the combustion chamber and the duration
depending on the load being carried out.
WARNING: It is absolutely forbidden to use water
to turn off the appliance. ELECTRIC SHOCK DANGER
AND ELECTRICAL DAMAGE TO THE APPLIANCE.
31. MAINTENANCE AND CLEANING
WARNING: First to make any kind of maintenance
or cleaning intervention the appliance must be switched
off, cold and be disconnected from power supply.
To maintain your appliance's efficiency, you must perform the
following periodic maintenance and cleaning.
DAILY CLEANING
WARNING: This cleaning operation is mandatory
and must be performed every day before the next
ignition. Depending on the type of installation, the
characteristics of the chimney and the quality of the
pellet used, after 8 hours of operation, additional
cleaning of the appliance may be necessary to restore
the ideal operating conditions.
Use a vacuum cleaner to remove all pellet and ash particles
accumulated in the brazier and in the entire combustion chamber.
Remove the ash grate around the brazier.
Aspirate the bottom ash drawer.
Reposition the ash grid in its seat
Glass
: For cleaning the glass, use a cloth that does not leave hair
together with our detergent or a specific detergent for stoves and
fireplaces: make sure that the air holes are not blocked.
WARNING: Do not spray the cleaning product
directly on the glass but only on the cloth used.
The cleaning chemicals used must not rest on the silk
screen of the glass. WE DO NOT ACCEPT ANY
RESPONSIBILITY FOR DAMAGING THE SILK SCREEN.
Summary of Contents for Pellicano M14
Page 14: ...L ARTISTICO SRL IT 14 Cod 40014 Rev 04 08 06 2018 32 SCHEMA ELETTRICO ...
Page 16: ...L ARTISTICO SRL EN 16 Cod 40014 Rev 04 08 06 2018 ...
Page 29: ...L ARTISTICO SRL EN 29 Cod 40014 Rev 04 08 06 2018 32 ELECTRICAL DIAGRAM ...
Page 31: ...L ARTISTICO SRL 31 Cod 40115 Rev 04 08 06 2018 ...
