2
Instruction Manual
Cable and Bar Cutter “CC0018”
INDEX
1.
BEFORE USING THE EQUIPMENT --------------------------- 2
2.
TECHNICAL FEATURES --------------------------------------- 2-3
3.
ESSENTIAL SAFETY REQUIREMENTS --------------------- 3
4.
START-UP ------------------------------------------------------------- 4
5.
MAINTENANCE ----------------------------------------------------- 4
6.
WARRANTY ---------------------------------------------------------- 4
7.
DECLARATION OF CONFORMITY --------------------------- 5
ANNEX
GENERAL DRAWING
1. BEFORE USING THE EQUIPMENT.
Remove the tool from its packaging and check for external damage, such as:
o
Broken cutting blade.
o
Damaged levers.
o
Loosed/unscrewed parts.
LARZEP hydraulic tools are designed in accordance with internal quality standards, in compliance with the ISO 9001 regulation.
The tools are designed for the applications described in this manual. Any other use may pose a risk to the equipment and result in hazardous situations for the
operator. Always use the tools in well-lit areas.
The manufacturer accepts no responsibility for damage resulting from the improper use of the tool.
The operator should be fully aware of the risks inherent in the use of high-pressure hydraulic tools, and should act responsibility in accordance with that described in
this manual, ensuring both his/her own safety as well as the safety of others located in the vicinity of the working zone.
The working instructions should be available for the operator at all times. In addition to reading and understanding the instructions manual, the operator should be
trained in the use of the machine and in the standards and regulations governing operations of this kind, such as those pertaining to accident prevention and
environmental protection, for example. All exposed personnel should use appropriate personal protection equipment: boots, helmet, goggles, gloves and protective
clothing.
Boots
Helmet
Goggles
Gloves
Clothes
2. TECHNICAL FEATURES.
The tools in the CC cable cutter range are designed to cut cables and bars in accordance with the specifications contained in the table below. Any other use not
included in the said specifications may cause irreparable damage to the cutter and render it unable to carry out the task for which it was designed.
When using the cable cutter, the operator should take steps to prevent the cable from fraying. We recommend that, before commencing the cutting operation, the
cable be attached to either end of the cutting zone, using tape, wire or another similar means.
The operator should take appropriate steps at all times to prevent exposure to flying particles of cable or bar generated during the cutting process (personal
protection equipment, protection screens, etc.).
MODEL
CC0018
CC0040
CC0075
CAPACITY
kN
54 kN
135 kN
70 kN
PRESSURE
bar
550 bar
700 bar
700 bar
WIRE ROPE
STEEL
Ext. mm
ALUMMINIUM
Ext. mm
18 mm
18 mm
40 mm
40 mm
40 mm
-
CABLE
TELÉPHONE
Ext. mm.
LEAD
Ext. mm
UNDERGROUND
Ext. mm.
-
18 mm
18 mm
-
40 mm
40 mm
75 mm
75 mm
75 mm
STEEL ROPE MAX.R = 1800 N/mm
Ext. mm.
WIRE min.mm.
18 mm
1 mm
32 mm
2 mm
-
-
BAR MAX.R= 400 N/mm
STEEL
Ext. mm
COPPER
Ext. mm
ALUMMINIUM
Ext. mm
12 mm
15 mm
15 mm
20 mm
30 mm
30 mm
-
-
-
BLADE
CRC 18
CRC-35-40
CRC75
DIMENSIONS
A mm
B mm
C mm
385 mm
60 mm
18 mm
490 mm
92 mm
41,5 mm
650 mm
126 mm
77 mm
WEIGHT
kg
2,8 kg
5,6 kg
6,8 kg
Do not loose instruction manual.
Never use hydraulic equipment that is damaged or suspected to be in poor condition.
