Larzep EE25030-CE, Instruction Manual

2

INSTRUCTION MANUAL 

Column Press with Electrical Pump "EE25030-CE"

    INDEX 
 

1. BEFORE USING THE EQUIPMENT .......................... 2 
2. TECHNICAL FEATURES ............................................. 3 
3. ESSENTIAL SAFETY REQUIREMENTS .................. 3-4 

3.1 GENERAL CONDITIONS 
3.2 COMMANDS 
3.3 SAFETY PREVENTION ACTIONS 
3.4 SECURITY IN MAINTENANCE 
3.5 INDICATIONS 

4. TRANSPORT AND ERECTION ................................... 4-5 
5. MAINTENANCE ............................................................. 6 
6. PROBLEMS ..................................................................... 6 
7. WARRANTY ................................................................... 6 
8. DECLARATION OF CONFORMITY .......................... 7 
     ANNEX 

•

GENERAL DRAWINGS 

1. BEFORE USING THE EQUIPMENT. 

Upon removing the protective packaging from the crane, carefully inspect it. Check for: 
 

1-

Oil leaks. 

2-

Signs of corrosion. 

3-

Damage to the hydraulic cylinder and hydraulic line. 

4-

Cracks or dents on the frame and the hydraulic cylinder’s attachments to the frame. 

5-

Loose or damaged screws or joints. 

6-

Damaged or incorrectly assembled accessories. 

 
If you find any damage or fault with the product, clearly label it and place it in a location where it will not be available for use until an authorized service dealer has 
repaired the fault. 
 

 
Familiarize yourself and your co-workers with the equipment. Before you begin using the jack, carefully read and observe all instructions and recommendations 
enclosed in the packaging.  
 
Your negligence in this matter may cause personal injury or material damage. 

 
Do not operate hydraulic equipment near open flame, explosives, sources of intense heat or any other hazard, which could cause a fire or the damage equipment. The 
hydraulic equipment should not be exposed to temperatures grater than 60ºC when in use or when stored. 

When choosing a place for the press, ensure that it will be located over firm, level ground such that the entire base of the press contacts the ground. If any doubt exists 
as to whether the ground will able to support the press and the additional weight it will see when in use, distribute the weight over a larger area by placing rigid steel 
beams or planks under the base of the press. 
 
Store the press with the cylinder’s piston fully retracted. 
 
 We recommend you wrap the cylinder in a protective plastic or place it in a location free of dirt, dust, steel shavings and other foreign matter, which can enter into the 
cylinder and damage its components. 
  

Never use hydraulic equipment that is damaged or suspected to be in poor condition. 

Do not loose the instruction manual. 

Do no store or leave the press where is can be accessed by the children. 

If purchasing just a cylinder or pump for use in a press, ensure that you are using the proper combination of pump, cylinder and press frame before 

assembling the unit. We recommend you seek professional advise on the matter.