2
Instruction Manual
Hydrostatic Test Hand Pumps WIP0040, WAP0040
WARRANTY
LARZEP, S.A.
guarantees its products against all design and manufacturing defects for two years from the date of
purchase. This guarantee does not include the ordinary wear of both metal and non-metal parts, abuse, using the
equipment beyond its rated capacity and any wear or damage incurred as a result of using a hydraulic fluid which is
not recommended by
LARZEP, S.A.
Please note that if the equipment is disassembled or serviced by anyone other than an authorized service dealer or
by
LARZEP, S.A
., this guarantee is rendered null and void.
In the event of a warranty claim, return the equipment to
LARZEP, S.A
. or the authorized dealer which sold you the
hydraulic equipment.
LARZEP, S.A
. will repair or replace the faulty equipment, whichever is deemed most
appropriate.
LARZEP, S.A.
shall not be held liable for any consequential damages or losses, which may occur as a
result of faulty equipment.
BEFORE USING THE EQUIPMENT AND ESSENTIAL SAFETY REQUIREMENTS
-
Hydraulic test pumps WAP0040 and WIP040 are designed for testing water. Use the pump only for the purpose
for which intended. Comply general safety instructions.
-
All pumps are tested individually.
-
Read the instruction manual carefully and practise using the equipment before application.
-
Always use protective goggles, safety shoes and protective gloves.
-
Do not modify the device (welded parts, lengthening drive levers, etc.).
-
Avoid dangerous environment influences (i.e. inflammable fluids or gases).
-
Place the equipment on a flat and solid area with adequate lighting.
-
Never tighten or loosen connections while they are under pressure.
-
The pump cannot be pressurised without being connected to an item to be pressurized unless a blanking plug is
fitted to the outlet port.
-
Use PTFE (Teflon) tape or in liquid or fillets paste on all threads to prevent any leakage.
-
Connect one end of the hose to the pump and the other end to the system or equipment to test (pipe, tank,
valve, etc..), paying attention to the "hydraulic seal". The pump is supplied with a 1 metre hose (both ends 1/2”
female).
-
Before starting operation, check that the installation is correct, the operator position is safe and the working zone
is out of bounds to all personnel.
-
Check the unit for damage. Replace any damage part immediately.
-
Never exceed the maximum working pressure of the pump. Ensure that all the equipment and accessories are
suitable for the maximum working pressure.
-
In all cases, the operator should have received adequate training regarding the handling of the device and logical
safety criteria associated with the movement of heavy loads.
-
The acoustic pressure level during application is less than 83 dB.
