Issue 1
Page 11 of 24
EL-SMS-2G-TP / TP+ / PROBE-G USER MANUAL
In order for the alarm condition to be cleared the temperature must rise and stay
above 12°C for at least 30 minutes.
Operating Modes
The ELSMS2G devices have three operating modes, these are:
Standby mode
Setup mode
Run mode
Standby Mode
Standby mode is the mode that the unit will be in when it is idle, i.e. when the unit
is not being setup or running. This state consumes minimal power. A one second
press of the “Status” button will confirm if the unit is in this state. The unit will show
either four green or five red LED flashes. Four green LED flashes mean the unit
is ready to begin its first setup attempt. Five red LED flashes mean that the last
attempt to set up the unit failed but it is ready for another attempt.
The unit will enter standby mode under the following conditions:
●
When it is powered on and the unit is not configured.
●
When it is powered on and the unit was configured but the real time clock
has reset due to an interruption to the power (e.g. if the batteries ran flat
during operation).
●
When an attempt to setup the unit has been made and does not complete
successfully.
User Guide
●
When the unit is in run mode and the stop monitoring button sequence
is pressed.
Setup Mode
This is the mode that allows a configuration SMS to be sent to the unit via the App.
The unit will not receive a configuration message until you have followed the steps
below and the unit is ready to receive it. If you try sending a configuration message
before this, the unit will not receive it. The configuration process can be started from
either standby or run mode.
Configuring the Unit
●
Use the App to select the parameters you require.
Note that the Apps do not save settings for each device. The Android App will
remember the settings used for the last device configured.
●
In the App, press the “Start” button (Android) or “Send SMS Message” (iOS)
at the bottom of the “Setup” screen.
●
Push the “Status” button on the ELSMS unit for five seconds and then
release the button. The red LED should begin flashing once every five
seconds. Wait until you hear a triple beep from the sounder. When this
happens the LED will change to a double green LED flash every five
seconds.
●
The ELSMS unit is now ready to receive the configuration SMS. Go ahead
