7
www.lasertools.co.uk
Instructions
Instructions
Fitting a disc:
WARNING:
Remove battery pack before fitting or removing grinding/cutting discs.
• Always work with guard in place — adjust guard to suit work angle (Fig. 3).
• Press spindle lock button to lock gearbox (Fig. 1).
• Use supplied pin-wrench to loosen / tighten the flange nut when replacing or changing
grinding or cutting discs (Fig. 4).
• Orientation of flange nut depends on the fitment of a flat cutting disc, a depressed centre
cutting disc, a flat grinding disc or a depressed centre grinding disc (Fig. 5).
• Ensure flange nut is fully tightened with spindle locked. Release spindle lock button when
tight.
WARNING:
Do not use discs that are cracked or damaged.
• The ON/OFF switch (3 in Fig. 1) is designed to avoid accidental starting — push forward
then press down to lock in the ON position.
• To switch OFF, press down on rear of switch, it will slide back and OFF.
WARNING:
The grinder will kick to the right when it starts — be aware of this and ensure
that it is gripped tightly in both hands. Choose the position for the side handle to maintain
comfortable use and stability (Fig. 6).
