This procedure must be done in the follows cases:
If It’s necessary to learn a
transponder/ultrasonic module.
new
If is necessary to delete a transponder/ultrasonic module from the memory of the alarm system.
PRELIMINARY OPERATIONS
To perform the learning procedure you must have at least a working/learning transponder.
Check that the alarm is disarmed, otherwise disarm it by the working transponder.
Open the bonnet of the vehicle.
Disconnect the Siren at least 5 seconds from power after that reconnect it.
Check that all the vehicle doors are close and the inside of the vehicle is empty (no movement can
be seen by ultrasonic sensors).
LEARNING ENTRY PROCEDURE
In order to enter the learning procedure is necessary
1A) Press the bonnet contact 3 consecutive times.
As confirm the siren will emit a short “beep”
1B) Where the bonnet contact is not present, is necessary connect and
disconnect from ground
the grey wire of the siren for 3 consecutive times.
As confirm the siren will emit a short “beep”
2)
Press
and
hold
the
button
of
the
for
about
3
seconds
until
the
LED
on
the
working transponder
transponder will emit 2 quick flashes then release the button immediately.
The entry process will be signalled by 2 beeps from the siren
LEARNING PROCEDURE
At the double led blinking
release the button
X2
Hold for 3 seconds
3”
2 beeps from the siren
X2
1 short beep of the siren
X1
1 short beep
of the siren
X1
X3
X3
Connect the grey wire to ground
Disconnect the wire from ground
+
Push the bonnet contact 3 times
PAG. 22
Summary of Contents for LA251
Page 32: ......
