41
CAREFULLY CONSULT THE INSTRUCTION AND MANUTENTION BOOKLET
BEFORE UNPLUG THE NEGATIVE POLE OF THE VEICHLE.
ATTENTION TO THE DISPOSITIVES OF AIR BAG AND CAR RADIO
CODICATED.
WARNINGS FOR INSTALLATION
!
ELECTRICAL CONNECTIONS
Dont strech or shortn the antenna wire, the shielded cables of ultrasound sensor and
of elettronic socket .
The ELECTRONIC SOCKET/LED BUTTON must be fixed in a easy position
accessible and visible both inside and outside of the vehicle.
All eletrical connection must be done reliable and secure (by welding the junctions).
The isolament of junctions must be realized with material quality (electrical tape) to be
sure not provacate a short circuit.
RED WIRE
: connect to the positive of fuse service ,interposing a fuse
BLACK WIRE:
ground of the alarm, connect to the ground of vehicle.
YELLOW WIRE e YELLOW/RED
:
Factory default settings: Connect one of the two wire to right direction indicator and the other
one to the left direction indicator.
Other settings: Power outputs programmable via Personal ComputerOne or both outputs can
be use for provide the below signal:
Provide a positive signal in the alarm phase of the device for a time equal to the siren sound
cycle: 25 seconds
Provide a positive costant signal with alarm activeted. The Signal allow the abilition of elettric
power window module or the satellite alarm with positive command.
Provide a positive costant signal a vehicle in motion (ingnition key +15).If the device read the
veichle code in motion from BUS network data; the system will be provide a positive signal
on that wire.
Provide a positive costant signal when the vehicle reverse gear is engaged.If the device
reads data of the reverse gear on the bus network, the system will be provide a positive
signal on the wire in the presence of reverse gear.
Provide a costant positive signal in motion (ingnition key +15) up to speed of 15Km/h.If the
device reads the presence of the vehicle code in motion from the canbus network, the
system will
Provide the positive signal on this wire only if the vehicle speed is under 15km/h
PURPLE WIRE
:Connect to a positive ingnition key. On that wire must be always present a positive
signal both in the ignition phase and with the engine running. (This signal can be detected from
CANBUS see
fi
le ISAUTO vehicle functionality)
RED/GREY WIRE CAN HIGH and RED/BROWN CAN-LOW:
data input wire of the CANBUS
type vehicle network (The system can protocol via network the arm data and disarm data, depend of
the model of veichle)
Set the code of the veichle with button of control unit or via P.C
YELLOW/GREY WIRE
: Programmable input via PC
It is automatically selected like input data LIN BUS of the network of the vehicle (The system can
protocol via network the arm data and disarm data, depend of the model of veichle)
Otherwise the input is set as a factory on command auxiliary alarm input
in this case it is also possible to enable all the options allowed for the alarm input wires see
description of the input wires, doors, hood and trunk.
