50
In order to arm/disarm through the direction indicators, the system must learn the vehicle locking
(arming) signals.
To activate this function is necessary: connect the WHITE/ORANGE, GREEN/BLUE and
YELLOW/BLUE wires to the direction indicators and then proceed as follow:
Close all doors,bonnet and trunk, leave the door open only where connections are being made
Connect the control unit, make sure the product is disarming (status LED off)
Press and KEEP pressing the button rear of the control unit after trhee second the led RED
will turn ON.
Keep pressing till the LED will be GREEN thats indicate the entry to the procedure
learnig analog signal.
Press and keep pressing the button till the led will turn GREEN
Close all doors opens and push the lock button of the original
radio control of the vehicle.
After the flashing of the direction indicators are ended,
present at arming,the status led will turn off for 1 second
and the led of the control unit will flash of red for kit with 909
will a briefly acustic signal
Push the unlock button of the original radio control of the vehicle
Aftert the flashing of the direction indicators are ended,present at disarming,the status led flash
for one second and the led of control unit will turn green
for kit with 909 will a briefly acustic signal
Is recommended to repeat the procedure from point C
at least two / three times to allow the product to have
a more precise reading.
To finish the procedure (after the disarming indications) press
the present button on the control unit two ORANGE flashes and the switching off of the status
Attention LED indicate that the procedure was successful. THREE acoustic signals and the
RED LED lighting up indicate an error in signal storage. (Press the device button)
Release the button when the led turn GREEN and verify the status led installed on the vehicle
turn ON costantly
ON
LEARNING PROCEDURE FOR THE ANALOGUE SIGNALS OF THE CAR
USB
AFTER THREE SECONDS
RED
GREEN
AFTER 6 SECONDS
KEEP PRESSING
STATUS LED
CLOSE THE DOORS
ON
OFF
(Procedure to be carried out only if the arming / disarming is managed through the
direction indicators / engine door)
