18
LASER
LASER
LASER
LASER
LASER
Observe the laser receiver‘s operating instructions for line lasers.
!
Use an laser receiver (optional) to carry out
levelling at great distances or when the laser lines
are no longer visible. To work with a laser receiver,
switch the line laser to hand-held receiver mode
by pressing button 9 (handheld receiver mode
on / off). The laser lines will now pulsate with
high frequency, making the laser lines darker.
The laser receiver can detect these pulsating laser
lines.
5
Hand receiver mode
Optional: Working with the laser receiver GRX
4
Slope mode
Do not release transport restraint, push slide switch (2) to the right.
Switch on the lasers by holding down the selection button (7).
Press it again to set the selection. Sloping planes and tilts can now be
measured. In this mode, the laser lines will no longer align automatically,
which will be indicated by the laser lines switching off briefly, roughly every
five seconds.
The device can be switched off in any laser selection by holding down
the button (7).
!
EN
