12
2
3
4
The unit is properly calibrated when it displays the same
measurement value, i.e. the underlying surface‘s deviation
from absolute level, in both positions (0° and 180°).
!
3. Now turn the unit around horizontally (end-for-end) by 180°
such that its ends are positioned opposite where they previously
were but again exactly at the underlying surface marks (reverse
measurement).
Then press the READ button (1) again. -2- flashes.
The subsequent acoustic signal concludes the process.
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
READ
HOLD
CAL
REF
%
mm/m
SET
DigiLevel Pro
Re
v19W38
LASER RADIATION! DO NOT STARE
INTO THE BEAM! CLASS 2 LASER
< 1 mW · 635 nm · EN 60825-1:2014/AC:2017
LASERSTRAHLUNG!
NICHT IN DEN STRAHL BLICKEN!
LASERKLASSE 2 · < 1 mW · 635 nm
EN 60825-1:2014/AC:2017
DigiLevel Pro 60
A quality product from
GmbH & Co. KG
Donnerfeld 2, 59757 Arnsberg
Germany, Tel: +49 2932 638-300
Fax: -333, www.laserliner.com
WARNING
With magnet
on the bottom
Hold down the HOLD button (6) to keep displaying the current
measured value.
HOLD
5
1. Place the unit with its measuring edge (13) down on a straight
surface and mark the positions of the unit‘s ends on the under
-
lying surface (see Fig. below). Switch on device (1). To access
calibration mode simultaneously press buttons 1 and 3.
-1- appears on the display.
2. Then press the READ button (1). -1- flashes.
The display then changes to -2-.
Calibration
Button (5) allows the desired unit of measurement to be selected
(° degrees, %, mm/m).
Selection of unit of measurement
The DigiLevel Pro 40/60/80 can measure angles continuously to 360°.
– Switch the DigiLevel Plus on using the on/off switch (1).
– The slope angle is shown in the display (l). If slopes are measured
overhead, the direction of display adjusts automatically.
– The current slope direction is also shown by the symbol (a).
Make sure that the reference function is deactivated before
measuring.
!
Switching on and measuring
EN
Summary of Contents for 081.270A
Page 51: ...DigiLevel Pro 40 60 80 51...
