Inserting the batteries ACL 3C and Laserreceiver RX 51 (optional):
Open the battery compartment (9, I) and insert the batteries in accordance
with the installation symbols, ensuring the correct polarity. Close the cover.
Low battery charge: Replace the ACL 3C batteries when the LED‘s (13) flash
alternately.
Aligning the ACL 3C:
For approximate adjustment of the lasers, the top part
of the ACL 3C can be turned on the base. Precise positioning can then be
done with the precision adjustment knob (3). The adjustable feet (6) allow
the device to be positioned on sloping surfaces.
Switching on the ACL 3C:
Turn the ON/OFF switch (2) to the right, thereby
releasing the transport securing device. The lasers can now be individually
activated via buttons 11, 12. To obtain maximum visibility of the laser line, the
hand receiver mode must be switched off (button 10). In this case, it is not
possible to work with the laser receiver.
i
Note:
If the device is too far off the horizontal (more than 3°), the lasers will
switch off. Align the device using the adjustable feet (6) or place on a more
level surface. The round vial (8) is provided as an aid to alignment.
B
A
C
D
E
G
F
I
AutoCross-Laser ACL 3C / ACL 3C RX
A
Power indicator
B
Switch accuracy
short range / long range
C
LED for accuracy
green / red
D
ON / OFF switch
E
Sound ON / OFF
F
Receiver field for laser beam
G
LED’s for Laserindication (front,
side, backside)
h
Universal mount
I
Battery compartment (backside)
ENGLISh
11
h
