CondenseSpot Plus
15
7
8
ON
SET
°C
ON
°F
OFF
SET
SET
Cont LOK
ON
OFF
SET
SET
FAC
3 sec
In relation to buildings, the term thermal bridge refers to an area, e.g. an inside wall,
at which heat is transferred outwards faster than at the rest of the inside wall. When
viewed from the inside, the temperature of this area is lower than the surrounding
areas and when viewed from outside higher than the surrounding areas. This often
indicates faulty or inadequate insulation.
For this purpose, the CondenseSpot Plus compares the ambient temperature with the surface temperature.
If there are large differences in both temperatures, the device will trigger warnings in 2 stages: „CHK“ is
displayed in borderline cases or the display lighting changes to „blue“ or „red“ to indicate the differences
are very large.
Thermal bridge mode
Ambient temperature:
20°C
No thermal bridge
Ambient temperature:
20°C
Possible thermal bridge,
continue checking area
Ambient temperature:
20°C
Thermal bridge,
display lights blue with
acoustic signal
Ambient temperature:
12°C
Thermal bridge,
display lights red with
acoustic signal
Menu settings
Confirm
Confirm
Confirm
Continuous measurement
By selecting the „Cont LOK“ function, continuous measurements can
be carried out without having to permanently press the trigger button.
Factory setting
The „FAC“ function resets the device to the factory setting.
Continuous measurement starts by briefly pressing the trigger button.
A lock symbol appears on the display. The value is held (HOLD) by
pressing the button again.
EN
Summary of Contents for CondenseSpot Plus
Page 74: ...74 ...
Page 75: ...CondenseSpot Plus 75 ...
