Duraplane 360
13
EN
RX-READY technology enables line lasers to be used even in
unfavourable light conditions.The laser lines pulsate at a high
frequency and this can be picked up by special laser receiversover
long distances.
ON
External
influence
Automatic level
set-up phase
ADS activation:
press the tilt
button; the tilt
LED flashes every
second.
The
laser
switches off and
the tilt LED is lit
continuously.
ADS active after 20 seconds,
rapid flashing of the tilt LED.
ADS function
The ADS does not activate the monitoring function until 20 seconds
after the laser levelling procedure has been completed (set-up phase).
The tilt LED flashes every second during the set-up phase, rapid
flashing, when ADS is active.
!
The ADS is not active following switch-on. Once the device has
been set up, press the tilt button to activate the ADS, enabling
you to protect the laser from changes in position caused by the
device being disturbed by external factors. The tilt LED flashes to
indicate that the ADS function is active; see the diagram below.
The anti-drift system (ADS) prevents erroneous or inaccurate
measurements. How it works: continuous monitoring of the
alignment of the laser is activated 20 seconds after the ADS is
switched on. If the device moves due to external influences or
if the laser loses its height reference, the laser switches off and
the tilt LED lights up permanently. Press the tilt button twice
to continue. Erroneous and inaccurate measurements are thus
prevented simply and reliably.
1H360°
S
Number and direction of the lasers
H = horizontal laser
S = slopefunction
Summary of Contents for Duraplane 360
Page 74: ...74 ...
Page 75: ...Duraplane 360 75 ...
