SuperLine-Laser 360°
09
LASER
LASER
LASER
LASER
LASER
2
3
LASER
LASER
LASER
LASER
LASER
4
Horizontal and vertical levelling
Release the transport restraint, set slide switch (3) to „ON“. The horizontal laser line appears.
The laser lines can be switched individually with the selection button.
The transport restraint must be released for horizontal and vertical levelling. The laser lines flash
when the device is outside the automatic levelling range of 3°. Position the device such that it is
within the levelling range.
!
Slope mode
Do not release the transport restraint, set slide switch (3) to the mid-position and select the lasers
with the selector switch. Sloping planes and tilts can now be measured. In this mode, the laser lines
no longer align automatically. This is signalised by the laser lines flashing.
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at great
distances or when the laser lines are no longer visible.
To work with a laser receiver, switch the line laser to hand-held receiver
mode by keeping button 5 (hand-held receiver mode on / off) pressed.
The laser lines will now pulsate with high frequency, making the laser
lines darker. The laser receiver can detect these pulsating laser lines.
Follow the operating instructions of the corresponding laser receiver.
!
EN
Summary of Contents for SuperLine-Laser 360
Page 67: ...SuperLine Laser 360 67 ...
