SuperPlane-Laser 3D
09
EN
LASER
LASER
LASER
LASER
2
4
3
LASER
LASER
LASER
LASER
Slope mode
Do not release the transport restraint, set slide switch (2) to "OFF" and switch on slope mode by pressing
and holding (3 seconds) button 5. Select the laser with the selector button (5). Sloping planes and tilts
can now be measured. In this mode, the laser lines no longer align automatically. This is signalised by the
laser lines flashing.
The transport restraint must be released for horizontal and vertical levelling. The laser lines flash
when the device is outside the automatic levelling range of 3°. Position the device such that it is
within the levelling range.
!
Horizontal and vertical levelling
Release the transport restraint, set slide switch (2) to "ON". The horizontal laser line appears.
The laser lines can be switched individually with the selection button.
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at great distances or when the laser lines are no
longer visible. To work with a laser receiver, switch the line laser to hand-held receiver mode by keeping
button 5 (handheld receiver mode on / off) pressed. The laser lines will now pulsate with high frequency,
making the laser lines darker. The laser receiver can detect these pulsating laser lines.
Observe the laser receiver‘s operating instructions for line lasers.
!
Due to the special optics required to generate a continuous 360° laser line, the underlying
technology may cause differences in brightness in different areas of the line. This may lead
to different ranges in hand receiver mode.
!
Summary of Contents for SuperPlane-Laser 3D
Page 62: ...62...
Page 63: ...SuperPlane Laser 3D 63...
