M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
21
IV. SOFTWARE INSTALLATION
Install LaserPro Mercury driver to PC. Please follow the procedure below:
1.
Choose
Settings
and click
Printers
2.
Double click
Add printer
and start
Add printer wizard.
Then
Next step.
3.
Choose
Local
and click
Next step
4.
Choose
Have disk
and click
Next step
5.
Insert the
Mercury Driver
disk properly into the floppy drive then click
OK
6.
choose the port where your laser system is connected and click
Next step
7.
Name your system or bypass
8.
choose the driver to be default printer
9.
select
No
when asked to print a test page and click
Finish
Now the LaserPro Mercury printer driver is installed completely. Don't forget to
take the GCC driver disk from the floppy drive and store in a safe place.
V. OPERATION
Environment
z
A clean, well-ventilated room with a temperature of 15
℃
~ 25
℃
(60
℉
~78
℉
) (Strongly
suggested the temperature of 25
℃
) and a relative humidity between 30% and 40%, as an
office type environment.
z
Avoid from unstable voltage supply.
z
Short path for an effective air exhaust.
z
Have a fire extinguisher available at any time.
Flexible Utility of Your Memory Buffer
The standard memory buffer size of Mercury is 16M and can be expanded to 64M ( 32M SIMM
x 2).
You can choose
Multiple file
mode with limited memory to save files and re-call them for
constant applications. Or, you can choose
Single file
mode to get an unlimited data output
while still keep files that you saved before under multiple file conditions. However, the file sent
under
Single file
mode will not be saved. In other words, every time you want to engrave this
file, you have to re-send again from the host computer.
