M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
26
NOTE:
UP
key – After initializing, press this key will move up the table. LCD displays:
During working time (i.e. Start condition), this message won’t be shown.
When
Auto Focus
is under process, press
UP
key will stop the motion of Auto
Focus and change to up movement.
DOWN
key – Same as above function but the motion direction is opposite.
ESC (Escape)
Exit and back to the main menu.
NEXT FILE
This key is valid under
Multiple file
mode only. Press this key the LCD shows
The “
k
” message shows on the lower right corner expresses the k bytes memory that has been
left over in the buffer.
PPI
means pulse per inch.
File: #
shows the current working file number. Press
NEXT FILE
each time will increase 1
(i.e. 1, 2, 3…100) and recycle the counting. Once the buffer has received up to 100 files, the
LCD shows:
If a file received is out of memory, the LCD shows
RED BEAM
On/Off red beam
SPEED
Set up laser speed for desired effect. When working without using MERCURY’s driver, lower
case press
FUNCTION
key then select one of the sixteen setups then set up desired cutting
speed. No matter you are using MERCURY’s driver or not, you can change speed on the fly by
Focusing
Then do setup or send a file
to start a job
－
X.X
mm
File: #
x
file name
Speed:
xx
% 00:00
Power:
xx
% PPI:
xxxx
DPI:
xxx xxxxx
k
More than 100 files are not allowed
Please delete files then other files
Not a complete file due to out of
memory. Please delete some
and send again
