M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
3
QUICK MENU
1. Connect air exhaust system.
2. Setup computer and connect with engraving system properly.
3. Turn
ON
host computer system.
4. Install the MERCURY Driver. (for the first time use only)
5. Use Windows-based program (such as CorelDraw, PhotoShop, PhotoPaint, Illustrator,
CASmate, Signlab, EasySign, AutoCAD, etc.) to operate with the engraver.
6. Turn
ON
engraver. The lens carriage moves to the home position (upper left corner)
and the working table moves down 50mm approximately after system initialization. (If a
rotary attachment has been installed, the working table will move down to the bottom.)
7.
Auto-focusing:
under
STOP
status, put work-piece on the table, move X-axis (Please
refer to Fig. 3) and carriage by arrow keys to locate the lens carriage above the
engraving material (holding carriage by hands for prompt moving is acceptable under
STOP
condition but not recommended). Press
AUTO FOCUS
the table will move
upward and stop at the focal positionautomatically.
8. The following is an example by using
CorelDRAW V.11
. Please ready the engraving
graphic in CorelDraw, and follow the instruction below to start work.
1. Layout
2. Page
Setup
3. Set from Printer,
choose
Portrait
4. OK
5.
Edit desired file (picture etc.)
5. File
6. Print
7. Properties
8. Options,
choose
desired Mode
(refer to Fig. 11) then set up proper resolution,
power and speed
9. OK
10. Print
11. F
ile name is shown on LCD then press
START.
(
Please refer to page
16,
Start to Operate,
for detail operation in different mode
selection)
NOTE:
z
If the memory buffer is set up in
Single file / No Repeat
mode, under
START
condition,
the engraver will start to engrave/cut upon receiving a file. While if the memory
buffer is set up in
Multiple File
mode, receiving at least one complete file then press
START
to start a job (refer to page 20,
Start to Operate
).
z
Choices
of
DPI must be the same
for both editing and printing out a file.
z
Turn on the air exhausting system before engraving.
z
The
maximum loading weigh
t
of working table is
20 kg
.
